Saturday 21 February 2015

My Amiga 1000 has arrived!

Today I received my Amiga 1000!






Ever since I attended the local Adelaide Amiga Meeting in January this year, I wanted to get an Amiga 1000 again. I used to have one until about 10 years ago, when I sold it (along with a lot of other Amiga and various retro computer stuff) to fund my purchase of an Amiga 4000T (which I still have!).

The Amiga 1000 was the very first Amiga released, back in the mid 1980's.

This particular Amiga 1000 came up on Ebay recently, and it was a fair price so I got it. It is a bit yellowed on the keyboard especially, but fully functional - all the keys work:


The view of the rear ports on the Amiga 1000 - note the serial and parallel ports use opposite connector types to every other Amiga released - care needs to be taken here to avoid damaging the Amiga 1000 motherboard. The keyboard connector is a telephone connector type - also unique to this Amiga only:


The Amiga 1000 was made in Japan, unlike most of the Amiga models that followed (with the exception of the CDTV which was also made in Japan):


The back of the Amiga 1000 keyboard:


By default the Amiga 1000 comes with just 256k of memory! The memory expansion slot on the front of the Amiga 1000 allows an additional 256k expansion to be installed to being the total to 512k memory. As you can see, this Amiga 1000 has this expansion installed:


I connected it all up to make sure it works (with a RGB to SVGA Scan doubler attached externally), and sure enough, I soon got the Kickstart Disk prompt:


View of the Amiga 1000 setup and running on my desk - the keyboard can slide underneath the Amiga 1000 case when not in use:


The person I bought this from said that the Kickstart and Workbench disks worked fine, but none of the game disks worked. The reason for the game issue became clear to me when I noted that the only kickstart disk included was a v1.1 kickstart!


Most games needed v1.2 kickstart minimum to work properly, which explains why the seller couldn't boot the game disks he sold with it. I will sort this out a bit further down this blog entry.

Unlike all other Amigas, the Amiga 1000 does not have a kickstart ROM included on the motherboard. Instead, the kickstart is loaded from disk on each power on. There were Kickstart disks for v1.1, v1.2 and v1.3, with a few rare and older variants as well.

For now, the v1.1 Kickstart disk included does boot fine on the Amiga 1000, and soon I got the familiar Workbench disk prompt:


I then booted the V1.1 Workbench disk. Have to admit it has been a very long time since I have seen a V1.1 Workbench!


Close up view (sorry for crappy iPhone screen photo quality):


Having determined the Amiga 1000 worked, the next priority was to make a v1.3 Kickstart disk. When I sold my Amiga 1000 ten years ago, I included all the Kickstart disks with it since I assumed I wouldn't need them anymore. Heh, feeling stupid now.

So now I needed to create a new kickstart disk. Fortunately there is an easy way to do this via a program called WriteKickDisk (available on AmiNet here). This needs a Classic Amiga and does not work on the X1000 (I did try it though).

Using my Amiga 4000T, I then ran WriteKickDisk to transfer a Kickstart 1.3 ROM file (copied from my A2000 using a program called GrabKick) to a floppy disk:



So now I am ready to try my new Kickstart 1.3 disk on the Amiga 1000. I power off the Amiga 1000 so it prompts to load the Kickstart disk again:


..and Voila! It works. Kickstart 1.3 now up and running on the Amiga 1000:


Now I can load up the various game disks included with the Amiga 1000 which the previous owner couldn't get to work - Ghouls N Ghosts is shown below - works fine now:


As most Classic Amiga fans would know, it is very desirable to have 1MB memory in an Amiga - 512k is a bit limiting and many games don't run on less than 1MB.

Accordingly I have found and purchased a 512k memory expansion module for the Amiga 1000 that plugs into it on the right hand side connector. This will then give the system 1MB of memory. This right hand side connector is the same as the Amiga 500 Expansion connector, except that it is flipped around as it is on the right side (on the A1000) versus the left hand side (on the A500).


So expansion cards intended for the Amiga 500 can in theory be used in the Amiga 1000 by flipping them around - but there are many exceptions to this rule and physical restrictions depending on the expansion casing used!

I haven't received the 512k expansion module yet, and look forward to trying it out when it arrives!


I am also keen to see if Individual Computers releases the promised ACA1000 expansion to allow A1200 accelerators and Hard disk CF cards on the Amiga 1000, like the ACA500 does for the Amiga 500. That would be awesome!

I will clean up the Amiga 1000, and then take a peek inside the case another time as well to see what version of the motherboard is inside this Amiga 1000.

Potentially this Amiga 1000 system is a good candidate for a Gotek or HxC USB/SD floppy controller in place of the normal floppy drive to load games on it, in the absence of a hard disk or other accelerators to run hard disk based games. It would also make booting the kickstart disk each power on much less tedious. I even may try this out next!


11 comments:

  1. Ahhhhh...... nostalgia. Had a 1000 myself, traded-in to upgrade to a 2000.

    ReplyDelete
  2. Wojox
    Very nice case. Amiga 1000 is first PERSONAL COMPUTER !!!

    ReplyDelete
  3. I have I think 2 Amiga 1000s in boxes...unlike my A500 I originally purchased with the Rock Lobster Keyboard in the fall of 1988, when a game loads you do not hear the drive crunch through your speakers. What a sweet piece of hardware...because of my Amiga, I missed out on the Nes, Genesis and Snes when they reigned supreme. I would love a working Phoenix board to pump things up...

    cheers,

    SEADRIVE

    ReplyDelete
    Replies
    1. Are you interested in selling one of the Amiga 1000 systems?

      Delete
    2. Sorry for the late reply...I plan on keeping one A1000 original and upgrading the other with perhaps the new Vampire 2 accelerator....

      Delete
  4. How much did you pay for the Amiga 1000?

    * I still have one, AND an Amiga 2500, though haven't turned either on in, probably, 15 years. (And software, Team Yankee(?), F-29 Retaliator, Draw 2000, Silver, Forms in Flight.
    * I have a 'Golden Image' Hand scanner too!

    * Unfortunately I may have to THROW them out within 4 days as I'm moving, and can't take much with me. >;-((

    Anyone interested, please reply URGENTLY. Nb. I live in Cronulla, so a local buyer would be good! jabberwocky1707 AT gmail DOT com

    ReplyDelete
    Replies
    1. Oh wow! I hope you didn't throw those Amigas out!

      Delete
    2. I purchased one Amiga 1000 for $100 about 8 years ago and another for $400...hope yoru machines go to a great home.

      Delete
    3. Unfortunately, I had no choice!:-(((
      They were left behind in my garage, and AFAIK the landlord disposed of them.
      :,-((

      Delete
  5. Hi, please why was the Amiga 1000 made in japan?

    ReplyDelete
  6. great page... can you tell me Model of expasion board to attach on the right panel? thanks

    ReplyDelete

Note: only a member of this blog may post a comment.